Refrigeration · Commercial focus

Cold Rooms

Panel-built chill rooms engineered around your product turnover

Design, build, relocation and repair of walk-in cold rooms from 4m³ single-door units to multi-chamber distribution stores. Panel spec, door traffic and product pull-down all get calculated before a compressor is chosen.

Panel spec
75mm / 100mm PIR, food-grade skins
Design range
0°C – +8°C holding
Build time
3–7 working days typical
Extras
Strip curtains, ramps, racking, data logging

Deployment scope

  • 01Product pull-down load and door-opening frequency modelling
  • 02Floor build-up, coving and drainage detail
  • 03Evaporator placement to eliminate dead warm corners
  • 04Door heater tape, seals and safety release hardware
  • 05Full leak test and 24-hour temperature validation run
Failure modes we correct

What Actually Goes Wrong

  • —Rooms sized on volume alone, ignoring warm daily intake
  • —Panel joints separating after forklift knocks, dumping load
  • —Blocked drains icing floors into a slip hazard
Cold Rooms plant serviced by Reyds Refrigeration
Intake protocol

Cold Rooms Enquiry

Include equipment make, age and observed temperatures for a faster, more accurate response.