Cold Rooms in Tyger Valley

Tyger Valley is the corporate and hospitality heart of the northern suburbs: high-occupancy office towers, the centre's food court operators, hotels and a concentration of A-grade tenants who measure comfort in complaints per floor. Work here is dominated by VRV systems, after-hours scheduling and access coordination with building management.

Design, build, relocation and repair of walk-in cold rooms from 4m³ single-door units to multi-chamber distribution stores. Panel spec, door traffic and product pull-down all get calculated before a compressor is chosen.

Panel spec

75mm / 100mm PIR, food-grade skins

Design range

0°C – +8°C holding

Build time

3–7 working days typical

Extras

Strip curtains, ramps, racking, data logging

Scope for Tyger Valley sites

• 01Product pull-down load and door-opening frequency modelling
• 02Floor build-up, coving and drainage detail
• 03Evaporator placement to eliminate dead warm corners
• 04Door heater tape, seals and safety release hardware
• 05Full leak test and 24-hour temperature validation run

Faults we correct across Tyger Valley

• —Rooms sized on volume alone, ignoring warm daily intake
• —Panel joints separating after forklift knocks, dumping load
• —Blocked drains icing floors into a slip hazard